Posted by EoA (211.52.126.7) on January 06, 2006 at 19:32:38:
VTL Dorries SD800/1000, new in 1982
Max. working diameter(swing): 10000mm
Max. working diameter of slide on crossbar: 10000mm
Max. distance between table and lower point of tool block of left slide:5600mm
Max. distance between table and lower point of tool block of right slide:5700mm
Max. distance between table and lower point of crossbar:6400mm
Crossbar
Travel:4740mm
Crossbar side slide
Number of slides 2 1
Max. Vertical travel of left slide carrier 3000mm 5700mm
Max. Horizontal travel of left slide carrier 5200mm 1500mm
Max. Vertical travel of right slide carrier 3000mm
Max. Horizontal travel of right slide carrier 5200mm
Accelerated travel on both directions
Rotated to: +/- 30 degrees +/- 30 degrees
Min. Distance between carrier’s center 2350mm
Type of tool clamping for right slide - 1
Type of tool clamping for right slide 4
Cross area of tool 60x60 60x60
Carries of milling machine/ number of tool seat 1
Turret head/number of tool seat 4
Table diameter 8000mm
Space for installation
Width: 16600mm Depth: 12600mm Height:20030mm
Table RPM constant torsional moment constant power
RPM range I 0.15-1.06 1.06-3.3
RPM range II 0.4-3 3-9
RPM range III 1.09-8.3 8.3-25
Feeds: 0.05-500 mm/min
0.07-10 RPM
Accelerated motion: 3000mm/min (slides)
350mm/min (crossbar)
Decelerated motion
1. 2mm/min
2. 40mm/min
3. 400mm/min
Max. torsional moment of table: 630000 Nm
Max. cutting force of one slide: 100000 N
Total cutting force: 150000 N
Feed force: 50000 Nm
Torsional moment of milling: 1175 Nm
Torsional moment of grinding: 71.6 Nm